How to add connectors in the design?

A connector can be used in the design to route any peripheral component connections to a connector. Please note the part selection is left to the user and the designs would be created with the dummy part connector details.

Add connector block from the left side to the canvas and define the number of pins supposed to be in the connector. Press ok and note the connector id JXX.

To route any connection to the connector select a peripheral and press route interface to connector icon as shown below:

connector_selection

next select the connector part number to route the processor interface connections to the connector

connector_id_selection

 

Was this answer helpful ? Yes (0) / No (0)